Cub Cadet Series 390 Instrukcja Operatora Pobierz pdf (Strona 25)

Cutting Deck Removal

To remove the cutting deck, proceed as follows:



position and engage the parking brake.

Lower the deck by moving the deck lift lever into the 2.

bottom notch on the right fender.





4.

Remove the hex screws.a.

Pull the belt keeper rod to the right and down to b.

remove.

c.



NOTE: If there is too much tension on the belt for it to be



a ⁄ drive ratchet wrench (set to loosen) into the square

hole found in the left-hand deck idler bracket and pivot it



See Fig. 7-2.

WARNING! Avoid pinching injuries. Never place

your fingers on the idler spring or between the belt

and a pulley while removing the belt.

Looking at the cutting deck from the left side of the tractor, 5.

locate the deck support pin on the rear left side of the

deck.

Belt Keeper

Rod

Figure 7-1

Belt Guard

Figure 7-2

Service

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Brak uwag

Cub Cadet Series 390 Instrukcja Operatora Strona 25