Cub Cadet 221 HP Instrukcja Operatora Pobierz pdf (Strona 7)

Assembly & Set-Up

Contents of Carton

• One Snow Thrower • One Chute Assembly • One Chute Rotation Control Assembly

• Two Ignition Keys • One 20 oz. Bottle 5W-30 Oil • One Electric Starter Cord (If equipped)

• One Snow Thrower Operator’s Manual • One Engine Operator’s Manual

NOTE: This Operator’s Manual covers several models. Snow

thrower features may vary by model. Not all features in this

manual are applicable to all snow thrower models and the snow

thrower depicted may differ from yours.

NOTE: All references to the left or right side of the snow thrower

are from the operator’s position. Any exceptions will be noted.

Unpacking the Snow Thrower

1. Open the top of the carton.

2. Cut down the corners on the front of the carton and fold

down the front side.

3. Pull the snow thrower out of the carton. Be sure not to

damage the chute, chute rotation control assembly or any

cables attached to the chute. Some of these parts are shipped

under the shroud on the backside of the carton. Check for any

cable ties securing the chute and remove if necessary.

Set-Up

Adding Fuel & Oil

Refer to the Engine Operator’s Manual packed with your snow

thrower for information on adding fuel and oil.

Assembly

Positioning the Upper Handle

1. Remove the wing knob and carriage bolt from the top

of the lower handle. See Figure 3-1. It is not necessary to

remove the shoulder screw and flange lock nut below the

wing knob and carriage bolt.

Wing Knob

Carriage Bolts

Figure 3-1

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Brak uwag

Cub Cadet 221 HP Instrukcja Operatora Strona 7