Cub-cadet 5254 Series Instrukcja Użytkownika

CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 [www.cubcadet.com]IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYWarning: This unit

10NOTE: References to LEFT and RIGHT indicatethat side of the tractor when facing forward whileseated in the drivers seat. Reference to FRONTindicat

11H. Hand HoldsHand holds are built into both the left and right hand fender covers. The handles can be used to assist in mounting and dismounting th

12T. Differential Lock PedalFigure 8 Located at the front of the left running board, thedifferential lock pedal engages the transmissiondifferential

13X. Instrument PanelFigure 12 1. Fuel GaugeThe fuel gauge monitors, at 20 second intervals, thefuel level in the fuel tank. The needle pointing to

14SECTION 2: OPERATIONROLLOVER PROTECTIVE STRUCTURE (ROPS)This tractor is equipped with a Rollover ProtectionStructure (ROPS) and seat belts. When us

15WARNING: Gasoline is extremelyflammable and can be explosive incertain conditions. Do not fill the fueltank when the engine is running orwhile the

16COLD WEATHER STARTINGBe sure to use the proper oil for the expectedtemperatures and use winter grade fuel. Follow thenormal engine starting instruc

17USING THE FORWARD AND REVERSE PEDALSThe hydrostatic transmission provides constantlyvariable ground speeds within the speed rating ofeach transmiss

18DRIVING ON SLOPESWARNING: Do not operate on inclineswith a slope in excess of 15 degrees (arise of approximately 2-1/2 feet every10 feet). The trac

19USING THE HYDRAULIC LIFT LEVERThe hydraulic lift system provides power for raisingand positioning three point hitch and belly mountedequipment. To

2TABLE OF CONTENTSTO THE OWNER ...

20Hazard LightsAlways use the flashing amber hazard lights alongwith the SMV (Slow Moving Vehicle) emblem whenoperating the tractor on, or near, road

21USING THE HITCH PLATEUse only the hitch plate (Refer to Figure 23), fortowing pull-behind equipment (carts, trailers, etc.)or dragging loads.Raise

22SECTION 3: ADJUSTMENTSADJUSTING THE SEATFor the comfort of the operator, a single leveradjustable seat is provided to set the fore to aftposition o

23• The length of the upper hitch link is normallydetermined by the design of each implement.To adjust the upper hitch link, loosen the lock-ing leve

24ADJUSTING THE BRAKESThe tractor brakes are adjusted at the factory andshould experience minimal wear if the tractor isoperated normally. However, a

25SECTION 4: MAINTENANCEThe service life and reliability of any machinedepends upon the care it is given. Proper lubrica-tion and maintenance is a vi

26LUBRICATION AND MAINTENANCE CHART (ILLUSTRATION)21125667789101111121314151617181818192041432121222366

27LUBRICATION AND MAINTENANCE CHART† More often when operating under dusty conditions.Ref.No.Operation tobe PerformedService IntervalsBeforeeach useE

28ACCESSING THE ENGINE COMPARTMENTWARNING: If the tractor has beenrecently operated, engine surfaces(including the radiator) will be HOT.Allow the en

29BATTERY REMOVALWARNING: Battery posts, terminalsand related accessories contain leadand lead compounds. Wash handsafter handling.The battery is loc

3www.cubcadet.comCUB CADET LLCP. O. BOX 361131CLEVELAND, OH 44136DEALER LOCATOR PHONE NUMBER: 877-282-8684Model Number Mfg. DateXXXXXXXXXXX XXXXXXXXX

30HEAD LIGHT BULB REPLACEMENTThe tractor is equipped with headlights. If one of thebulbs should burn out, replace the bulb as follows:• Fully raise t

31Accessing the Fuse CenterThe fuse center is located on the inside right of thedash panel. To access the fuse center, remove thedash panel insert by

32CHECKING TRANSMISSION/HYDRAULIC SYSTEM OIL LEVELCheck the hydro transmission/hydraulic system oillevel before each use. NOTE: Check the oil levelo

33• Remove the old hydrostatic filter by turning itcounterclockwise, and immediately replace withthe new filter. Turn the filter clockwise by handunt

34Dispose of used oil in an environmentallysafe manner. If necessary, contact yourarea EPA office for proper disposal proce-dures and recycling cente

35• To prevent debris from entering the front axlehousing, clean the area around the oil fill plug/dipstick and the axle drain plug located at thecen

36TIRE MAINTENANCECheck the tire air pressure after every 50 hours ofoperation or weekly. Keep the tires inflated to therecommended pressures. Improp

37TRACTOR STORAGEIf your tractor is not going to be operated for anextended period of time (thirty days to approxi-mately six months), the tractor sh

38SECTION 5: ENGINE INFORMATION AND MAINTENANCEKAWASAKI LIMITED WARRANTYCALIFORNIA AND FEDERALEMISSIONS CONTROL SYSTEMSSMALL OFF-ROAD ENGINESThe Cali

393. LIMITED LIABILITY.(a) The liability of Kawasaki under this Emission Control Systems Warranty is limited solely to the remedyingof defects in ma

4IMPORTANT SAFE OPERATION PRACTICESWARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IFNOT FOLLOWED, COULD ENDANGER THE PERSONAL S

40ENGINE MAINTENANCEWARNING: Use care when servicingany component in the engine area. Ifthe engine has recently been operated,components will be hot

41ADDING ENGINE OILWARNING: Never overfill the enginecrankcase. The engine may overheatand/or damage may result if thecrankcase is below the “ADD” ma

42• Turn the valve drain cock fully clockwise toclose the valve, and clean any residual oil fromthe valve. Refer to Figure 53.• Apply a light coating

43INSPECTION OF COOLING SYSTEM HOSESCheck the cooling system hoses for any cracks ordeterioration every 200 hours of operation. Checkall hose connect

44SERVICING THE FOAM PRECLEANERWash the foam precleaner every 25 hours ofoperation. Wash more often when operating underextremely dusty conditions. R

45SECTION 6: SPECIFICATIONSEngineManufacturer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

46SPECIFICATIONS Hydraulic Lift SystemType . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

47SECTION 7: OPTIONAL EQUIPMENT AND ACCESSORIESWhen purchasing your tractor, you probably had it equipped for your particular needs at that time.You

Proper maintenance of your Cub Cadet equipment is the owner’s responsibility. Follow the instructions in your owner’smanual for correct lubricants and

5• Disengage all attachment clutches, thoroughlydepress the brake pedal and shift into neutralbefore attempting to start the engine.• Your mower is d

63. CHILDREN• Tragic accidents can occur if the operator is notalert to the presence of children. Children areoften attracted to the machine. Never

7• Keep all nuts, bolts and screws tight to be surethe equipment is in safe working condition.• Never tamper with safety devices. Check theirproper o

8SAFETY LABELSINSTRUCTION / WARNING LABELON LEFT RUNNING BOARDAVO ID SERIOUSINJURY OR DEATHREAD OPERATOR'SWARNINGGO UP AND DOWN SLOPES,NOT ACRO

9O.N.M.L.K.SECTION 1: CONTROLS AND FEATURESFigure 1 A.B.C.D.E.F.J.Steering WheelPTO SwitchThrottle HandleIgnition SwitchBrake PedalReverse PedalPTO